Supermicro SuperServer 5019P-WT - Page 44

Chapter 6: BIOSSuperServer 5019P-WT/WTR User's Manual
8180
Server ME Conguration

• Oper. Firmware Version
• Backup Firmware Version
• Recovery Firmware Version
• ME Firmware Status #1
• ME Firmware Status #2
• Current State
• Error Code
PCH SATA Conguration
When this submenu is selected, the AMI BIOS automatically detects the presence of the SATA
devices that are supported by the Intel PCH chip and displays the following items:
SATA Controller
This item enables or disables the onboard SATA controller supported by the Intel PCH chip.
The options are Disable and Enable.
Congure SATA as

AHCI and
RAID.
SATA HDD Unlock
This feature allows the user to remove any password-protected SATA disk drives. The options
are Enable and Disable.
Aggressive Link Power Management
When this item is set to Enable, the SATA AHCI controller manages the power usage of the
SATA link. The controller will put the link in a low power mode during extended periods of I/O
inactivity, and will return the link to an active state when I/O activity resumes. The options
are Disable and Enable.
*If the item "Congure SATA as" above is set to RAID, the following items will display:
SATA RSTe Boot Info
Select Enable to provide full int13h support for the devices attached to SATA controller The
options are Disable and Enable.
SATA RAID Option ROM/UEFI Driver
Select UEFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
SATA Port 0 ~ Port 7
This item displays the information detected on the installed SATA drive on the particular SATA
port.
• Model number of drive and capacity
• Software Preserve Support
Port 0 ~ Port 7 Hot Plug
Set this item to Enable for hot-plugging support, which will allow the user to replace a SATA
drive without shutting down the system. The options are Disable and Enable.
Port 0 ~ Port 7 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are Disable and Enable.
Port 0 ~ Port 7 SATA Device Type

State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
PCH sSATA Conguration
When this submenu is selected, the AMI BIOS automatically detects the presence of the SATA
devices that are supported by the Intel PCH chip and displays the following items:
sSATA Controller
This item enables or disables the onboard sSATA controller supported by the Intel PCH chip.
The options are Enable and Disable.
Congure sSATA as

      AHCI
and RAID.
SATA HDD Unlock
This feature allows the user to remove any password-protected SATA disk drives. The options
are Disable and Enable.