Supermicro SuperServer 5019P-WT - 4.1 Power Connections

Chapter 6: BIOSSuperServer 5019P-WT/WTR User's Manual
8584
VGA Priority
Use this feature to select VGA priority when multiple VGA devices are detected. Select On-
board to give priority to your onboard video device. Select Offboard to give priority to your
graphics card. The options are Onboard and Offboard.
M.2 PCI-E 3.0 X4 OPROM

The options are Disabled, Legacy, and EFI.
Onboard SAS Option ROM
Select Enabled to enable SAS Option ROM support to boot the computer using a SAS device
Legacy, and EFI.
Onboard LAN Device
Use this feature to enable or disable Onboard LAN devices. The options are Disabled and
Enabled.
Onboard LAN1 Option ROM

boot. The options are Disabled, Legacy, and EFI.
Onboard LAN2 Option ROM

boot. The options are Disabled, Legacy, and EFI.
Onboard Video Option ROM
Use this item to select the Onboard Video Option ROM type. The options are Disabled,
Legacy, and EFI.
Network Stack Conguration
Network Stack

Firmware Interface) for network stack support. The options are Enabled and Disabled.
IPv4 PXE Support
Select Enabled to enable IPv4 PXE boot support. The options are Disabled and Enabled.
IPv4 HTTP Support
Select Enabled to enable IPv4 HTTP boot support. The options are Disabled and Enabled.
IPv6 PXE Support
Select Enabled to enable IPv6 PXE boot support. The options are Disabled and Enabled.
IPv6 HTTP Support
Select Enabled to enable IPv6 HTTP boot support. The options are Disabled and Enabled.
PXE Boot Wait Time
Use this option to specify the wait time to press the ESC key to abort the PXE boot. Press
"+" or "-" on your keyboard to change the value. The default setting is 0.
Media Detect Count
Use this option to specify the number of times media will be checked. Press "+" or "-" on
your keyboard to change the value. The default setting is 1.
Super IO Conguration
The following Super IO information will display:
• Super IO Chip AST2500
Serial Port 1 Conguration

Serial Port 1
Select Enabled to enable the selected onboard serial port. The options are Disabled and
Enabled.
Device Settings

Serial Port 1 Change Settings
      
 Auto to allow the BIOS to automatically assign the
base I/O and IRQ address.
The options for Serial Port 1 are Auto, (IO=3F8h; IRQ=4;), (IO=3F8h; IRQ=3, 4, 5, 6, 7,
9, 10, 11, 12;), (IO=2F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;), (IO=3E8h; IRQ=3, 4, 5, 6, 7,
9, 10, 11, 12;), and (IO=2E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;).
Serial Port 2 Conguration

Serial Port 2
Select Enabled to enable the selected onboard serial port. The options are Disabled and
Enabled.