EasyManua.ls Logo

Supermicro SuperServer 5019P-WT - Page 52

Supermicro SuperServer 5019P-WT
73 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 6: BIOSSuperServer 5019P-WT/WTR User's Manual
9796
Subnet Mask
This item displays the sub-network that this computer belongs to. The value of each three-
digit number separated by dots should not exceed 255.
Station MAC Address
This item displays the Station MAC address for this computer. Mac addresses are 6 two-digit
hexadecimal numbers.
Gateway IP Address
This item displays the Gateway IP address for this computer. This should be in decimal
and in dotted quad form (i.e., 172.31.0.1).
VLAN
This item displays the virtual LAN settings. The options are Disable and Enable.
Congure IPV6 Support

LAN Channel 1
IPV6 Support
Use this feature to enable IPV6 support. The options are Enabled and Disabled.
Conguration Address Source
This feature allows the user to select the source of the IP address for this computer. If Static
is selected, you will need to know the IP address of this computer and enter it to the system


IP address for this computer. The options are Unspecied, Static, and DHCP.
*If the item "Conguration Address Source" above is set to Static, the following items
will become available for conguration:
Station IPV6 Address

IPV6 Router1 IP Address
6.6 Security

Administrator Password
Press Enter to create a new, or change an existing, Administrator password.
User Password
Press Enter to create a new, or change an existing, User password.
Password Check
Select Setup for the system to check for a password at Setup. Select Always for the system
to check for a password at bootup or upon entering the BIOS Setup utility. The options are
Setup and Always.

Related product manuals