1-2
SUPERSERVER 6048R-TXR User's Manual
1-2 Serverboard Features
At the heart of the SuperServer 6048R-TXR lies the X10DRX, a dual processor
serverboard based on the Intel C612 chipset. Below are the main features of the
X10DRX. (See Figure 1-1 for a block diagram of the chipset.)
Processors
The X10DRX supports two Intel
®
E5-2600 v3 series processors in LGA 2011 sockets
(Socket R3). Please refer to the serverboard description pages on our website for
a complete listing of supported processors (www.supermicro.com).
Memory
The X10DRX has sixteen DIMM slots that can support up to 1024 GB of LRDIMM
or 512 GB of RDIMM DDR4-2133/1866/1600 memory. Modules of the same size
and speed are recommended. See Chapter 5 for details.
Serial ATA
A SATA controller is integrated into the chipset to provide a ten-port SATA 3.0
subsystem, which is RAID 0, 1, 5 and 10 supported. The I-SATA0 through I-SATA5
ports are supported by the Intel PCH while the S-SATA0 through S-SATA0-3 ports
are supported by the Intel SCU. The SATA drives are hot-swappable units.
Note: The operating system you use must have RAID support to enable the hot-
swap capability and RAID function of the Serial ATA drives.
PCI Expansion Slots
The X10DRX has ten PCI-E 3.0 x8 and one PCI-E 2.0 x4 (in x8) slots for a total
of eleven PCI expansion slots.
Rear I/O Ports
The I/O ports include one COM port, a VGA (monitor) port, four USB 2.0 ports, a
dedicated IPMI LAN port and two Gb Ethernet LAN ports.
IPMI
IPMI (Intelligent Platform Management Interface) is a hardware-level interface
specication that provides remote access, monitoring and administration for
Supermicro server platforms. IPMI allows server administrators to view a server’s
hardware status remotely, receive an alarm automatically if a failure occurs, and
power cycle a system that is non-responsive.
To Next Page
Loading...
