Chapter 3: System Interface
3-3
HDD
On the SuperServer 6048R-TXR, this LED indicates SATA hard drive and/or DVD-
ROM drive activity when ashing.
Power
Indicates power is being supplied to the system's power supply units. This LED
should normally be illuminated when the system is operating.
3-4 Drive Carrier LEDs
Each drive carrier has two LEDs:
•Green: When illuminated, the green LED on the drive carrier indicates drive
activity. A connection to the backplane enables this LED to blink on and off
when that particular drive is being accessed.
•Red: The red LED to indicate a drive failure. If one of the drives fails, you should
be notied by your system management software. Please refer to Chapter 6 for
instructions on replacing failed drives.
To Next Page
Loading...
