Chapter 6: Advanced Chassis Setup
6-7
Installing a Peripheral Drive
The SC842XTQ-R606B chassis can support a slim DVD-ROM and up to three
5.25" peripheral drives.
Figure 6-4. Installing the Peripheral Drive
Installing a Peripheral Drive
1. Disconnect the chassis from any power source and remove the cover.
2. If adding a drive to the chassis, remove the mini-bezel from the drive bay
The mini-bezel is the small grating that covers the drive bay. Remove this by
simply pulling it out of the bay.
3. If replacing an existing drive, remove the existing drive by depressing the
release tab, then pulling the drive out of the chassis.
4. Attach the two guide screws which are included in the accessory box.
5. Insert the new drive unit in the slot until the release tab locks into place.
6. Connect the data and power cables to the serverboard.
1
4
Release Tab
Guide Screws
1
3
To Next Page
Loading...
