Supermicro SuperServer 6048R-TXR - Page 88

7-4
SUPERSERVER 6048R-TXR User's Manual
Boot Features
Quiet Boot
Use this item to select the bootup screen display between POST messages and
the OEM logo. Select Disabled to display the POST messages. Select Enabled
to display the OEM logo instead of the normal POST messages. The options are
Enabled and Disabled.
AddOn ROM Display Mode
Use this item to select the display mode for the Option ROM. Select Keep Cur-
rent to use the current AddOn ROM Display setting. Select Force BIOS to use the
Option ROM display mode set by the system BIOS. The options are Force BIOS
and Keep Current.
Bootup Num-Lock
Use this item to set the Power-on state for the Numlock key. The options are Off
and On.
Wait For 'F1' If Error
Select Enabled to force the system to wait until the 'F1' key is pressed if an error
occurs. The options are Disabled and Enabled.
INT19 (Interrupt 19) Trap Response
Interrupt 19 is the software interrupt that handles the boot disk function. When this
item is set to Immediate, the ROM BIOS of the host adaptors will "capture" Interrupt
19 at bootup immediately and allow the drives that are attached to the host adap-
tors to function as bootable disks. If this item is set to Postponed, the ROM BIOS
of the host adaptors will not capture Interrupt 19 immediately to allow the drives
attached to the adaptors to function as bootable devices at bootup. The options
are Immediate and Postponed.
Re-try Boot
Use this feature to force the system to reboot when the initial system boot has
failed. Select Legacy Boot to reboot the system using a legacy bootable device.
Select EFI to reboot the system using an EFI bootable device. The options are
Disabled, Legacy Boot, and EFI Boot.
Power Conguration
Watch Dog Function
If enabled, the Watch Dog timer will allow the system to reboot when it is inactive
for more than 5 minutes. The options are Enabled and Disabled.