Chapter 4: AMI BIOS
4-39
Erasing Settings
Erase SEL
Select Yes, On next reset to erase all system event logs upon next system reboot.
Select Yes, On every reset to erase all system event logs upon each system reboot.
Select No to keep all system event logs after each system reboot. The options are
No; Yes, On next reset; and Yes, On every reset.
When SEL is Full
This feature allows the user to determine what the AMI BIOS should do when the
system event log is full. Select Erase Immediately to erase all events in the log when
the system event log is full. The options are Do Nothing and Erase Immediately.
Note: After making changes on a setting, be sure to reboot the system for
the changes to take effect.
Custom EFI Logging Options
Log EFI Status Codes
Select Enabled to log EFI (Extensible Firmware Interface) Status Codes, Error
Codes or Progress Codes. The options are Disabled, Both, Error code, and Prog-
ress code.
BMC Network Confi guration
The following items will be displayed:
Update IPMI LAN Confi guration
Select Yes for the system BIOS to automatically reset the following IPMI settings
at next system boot. The options are No and Yes.
Confi guration Address Source (Available when the item above - Update
IPMI LAN Confi guration is set to Yes)
Use this item to select the IP address source for this computer. If Static is selected,
you will need to know the IP address of this computer and enter it to the system
manually in the fi eld. If DHCP is selected, AMI BIOS will search for a DHCP (Dy-
namic Host Confi guration Protocol) server attached to the network and request
the next available IP address for this computer. The options are Static and DHCP.
Station IP Address
This item displays the Station IP address for this computer. This should be in decimal
and in dotted quad form (i.e., 192.168.10.253).
To Next Page
Loading...
