Chapter 2: Installation
2-11
OPEN 1st
Installing a Passive CPU Heatsink
1. Do not apply any thermal grease to the heatsink or the CPU die -- the re-
quired amount has already been applied.
2. Place the heatsink on top of the CPU so that the four mounting holes are
aligned with those on the motherboard and the heatsink bracket underneath.
3. Screw in two diagonal screws (e.g., the #1 and the #2 screws) until just snug
(Do not over-tighten the screws to avoid damaging the CPU.)
4. Finish the installation by fully tightening all four screws.
Screw#1
Screw#2
Mounting Holes
Note: For optimized airfl ow, please follow the airfl ow direction of your
heatsink for proper installation. Graphics included in this manual are for
reference only. They may look different from the components installed in
your system.
Direction of Airfl ow
To Next Page
Loading...
