Supermicro X10SDV-TLN4F - CMOS Clear; PCI-E Slot SMB Enable; C1;I 2 C2)

Chapter 2: Installation
2-27
LAN3/4
LAN1/2
PCI-E3.0 X16
:TPM/PORT80
USB 2/3
USB 0/1(3.0)
USB 4/5
SLOT7
JBT1
IPMI_LAN
JGPIO1
DESIGNED IN USA
1
X10SDV-TLN4F
REV:1.01
LED3
J6
BMC
AST2400
i350
CPU
JUIDB1
I-SGPIO2
I-SGPIO1
JF1
JL1
JOH1
JD1
PJ1
JSTBY1
JPW1
LED8
LED7
LEDM1
BT1
FAN3
FAN2
FAN1
COM1
VGA1
JTPM1
JSD1
JPUSB1
JPME1
JPG1
JPB1
JI2C1
JI2C2
JSMB1
JPL1
JBR1
JPME2
I-SATA3
I-SATA1
I-SATA2
I-SATA5
I-SATA4
DIMMB2 DIMMA2
DIMMB1
DIMMA1
I-SATA0
JIPMB1
JNVI2C1
SRW2
SRW1
JWD1 JPTG1
J21
A. Clear CMOS
B. JI
2
C1
C. JI
2
C2
PCI Slot_SMB Enable
Jumper Settings
Pin# Denition
1-2 Enabled
2-3 Disabled (Default)
PCI-E Slot SMB Enable (I
2
C1/I
2
C2)
Use jumpers I
2
C1/I
2
C2 to enable PCI
SMB (System Management Bus) support
to improve system management for the
onboard PCI-E slot. See the table on the
right for jumper settings.
C
A
B
CMOS Clear
JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact pads
to prevent accidental clearing of CMOS. To clear CMOS, use a metal object such
as a small screwdriver to touch both pads at the same time to short the connec-
tion. Always remove the AC power cord from the system before clearing CMOS.
Note 1: For an ATX power supply, you must completely shut down the
system, remove the AC power cord, and then short JBT1 to clear CMOS.
Note 2: Be sure to remove the onboard CMOS Battery before you short
JBT1 to clear CMOS.
Note 3: Clearing CMOS will also clear all passwords.