Supermicro X10SDV-TLN4F - Watch Dog Timer Enable; LAN Ports Enable;Disable

2-28
X10SDV-TLN4F/F Motherboard User’s Manual
LAN3/4
LAN1/2
PCI-E3.0 X16
:TPM/PORT80
USB 2/3
USB 0/1(3.0)
USB 4/5
SLOT7
JBT1
IPMI_LAN
JGPIO1
DESIGNED IN USA
1
X10SDV-TLN4F
REV:1.01
LED3
J6
BMC
AST2400
i350
CPU
JUIDB1
I-SGPIO2
I-SGPIO1
JF1
JL1
JOH1
JD1
PJ1
JSTBY1
JPW1
LED8
LED7
LEDM1
BT1
FAN3
FAN2
FAN1
COM1
VGA1
JTPM1
JSD1
JPUSB1
JPME1
JPG1
JPB1
JI2C1
JI2C2
JSMB1
JPL1
JBR1
JPME2
I-SATA3
I-SATA1
I-SATA2
I-SATA5
I-SATA4
DIMMB2 DIMMA2
DIMMB1
DIMMA1
I-SATA0
JIPMB1
JNVI2C1
SRW2
SRW1
JWD1 JPTG1
J21
A
A. Watch Dog Enable
B. LAN Enable
Watch Dog Timer Enable
Watch Dog (JWD1) is a system monitor that
can be used to enter LAN bypass default set-
tings, reset the system or enter NMI when
the Timer expires. Close pins 1-2 to reset the
system if an application hangs. Close pins 2-3
to generate a non-maskable interrupt signal
for the application that hangs. Open all pins
to enter LAN pair default mode only. See the
table on the right for jumper settings. Watch
Dog may be enabled in the BIOS Setup. The
default timer is around 5 minutes.
Watch Dog
Jumper Settings
Pin# Denition
1-2 Reset (Default)
2-3 NMI
Open LAN pairs set to default
mode without reset
or NMI
LAN Ports Enable/Disable
Jumper JPL1 enables or disables Ethernet
LAN ports on the motherboard. See the table
on the right for jumper settings. The default
setting is enabled.
GbE LAN Enable
Jumper Settings
Pin# Denition
1-2 Enabled (Default)
2-3 Disabled
B