Supermicro X11SCA - Page 82

X11SCA/-W/-F User Manual
82
AST2500SEC Super IO Conguration
SOL Conguration
Serial Port 1
This feature will enable Serial Port 1 (COM1). Click to check the box to enable Serial Port
1. The default is Checked (Enabled).
Device Settings
Change Settings
This feature congures the IRQ setting for Serial Port 1 (COM1). The default is Auto.
Serial Port Console Redirection
COM1 Console Redirection
Check the box to enable COM Port 1 Console Redirection, which will allow a client machine to
be connected to a host machine at a remote site for networking. The options are Unchecked
(Disabled) and Checked (Enabled).
*If the item above set to Enabled, the following items will become available for
conguration:
COM1 Console Redirection Settings
COM1 Terminal Type
This feature allows the user to select the target terminal emulation type for Console
Redirection. Select VT100 to use the ASCII Character set. Select VT100+ to add color
and function key support. Select ANSI to use the Extended ASCII Character Set. Select
VT-UTF8 to use UTF8 encoding to map Unicode characters into one or more bytes. The
options are ANSI, VT100, VT100+, and VT-UTF8.
COM1 Bits per second
Use this feature to set the transmission speed for a serial port used in Console Redirection.
Make sure that the same speed is used in the host computer and the client computer. A
lower transmission speed may be required for long and busy lines. The options are 9600,
19200, 38400, 57600, and 115200 (bits per second).
COM1 Data Bits
Use this feature to set the data transmission size for Console Redirection. The options are
7 (Bits) or 8 (Bits).