X11SSH-CTF/TF User's Manual
122
7. Using a different system, extract the BIOS package into a bootable USB ash drive.
8. When a DOS prompt appears, enter FLASH.BAT BIOSname.### at the prompt.
Note: Do not interrupt this process until the BIOS ashing is complete.
9. After seeing the message that BIOS update has completed, unplug the AC power cable
from the power supply, clear CMOS, then plug the AC power cable in the power supply
again to power on the system.
10. Press <Del> continuously to enter the BIOS Setup utility.
11. Press <F3> to load the default settings.
12. After loading the default settings, press <F4> to save the settings and exit the BIOS
Setup utility.
6. After the BIOS recovery process has completed, press any key to reboot the system.
To Previous Page
Loading...
Need help?
General
