EasyManuals Logo

Supermicro X11SSH-CTF User Manual

Supermicro X11SSH-CTF
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #97 background imageLoading...
Page #97 background image
Chapter 4: BIOS
97
Intel Ethernet Controller X550 - 00:25:90:5D:AF:26
NIC Conguration
Link Speed
This feature allows the user to specify the port speed used for the selected boot protocol.
The options are Auto Negotiated, 10 Mbps Half, 10 Mbps Full, 100 Mbps Half, and 100
Mbps Full.
Wake On LAN
Select Enabled for Wake_On_LAN support, which will allow the system to "wake up" when
an onboard device receives an incoming signal. The options are Disabled and Enabled.
Blink LEDs
Use this feature to identify the physical network port by blinking the associated LED. Use the
keyboard to select a value.
UEFI Driver
This item displays the UEFI driver version.
Adapter PBA
This item displays the Processor Bus Adapter (PBA) model number. The PBA number is a
nine digit number (i.e., 010B00-000) located near the serial number.
Device Name
This item displays the adapter device name.
Chip Type
This item displays the network adapter chipset name.
PCI Device ID
This item displays the device ID number.
PCI Address
This item displays the PCI address for this computer. PCI addresses are three two-digit
hexadecimal numbers.
Link Status
This item displays the connection status.
MAC Address
This item displays the MAC address for this computer. Mac addresses are six two-digit
hexadecimal numbers.

Table of Contents

Other manuals for Supermicro X11SSH-CTF

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Supermicro X11SSH-CTF and is the answer not in the manual?

Supermicro X11SSH-CTF Specifications

General IconGeneral
BrandSupermicro
ModelX11SSH-CTF
CategoryMotherboard
LanguageEnglish

Related product manuals