Supermicro X12SPZ-SPLN6F - Page 110

Super X12SPZ-SPLN6F/LN4F User's Manual
110
Link FEC
Use this feature to congure the select the link forward error correction mode. The doptions
are Disabled, CL74 - Fire Code, CL91 - Reed Solomon, and Both CL74 and CL91.
Operational Link Speed
Use this feature to select the default link speed for this port. The options are AutoNeg,
1Gbps, 10Gbps, and 25Gbps.
Firmware Link Speed
Use this feature to select the default link speed for this port in D3 state. The options are
AutoNeg, 1Gbps, 10Gbps, and 25Gbps.
Support RDMA
Use this feature to enable or disable RDMA support for this port. The options are Disabled
and Enabled.
DCB Protocol
Use this feature to enable or disable DCB protocol. The options are Disabled, Enabled
(IEEE only), CEE (only), and Both (IEEE preferred with fallback to CEE).
LLDP nearest bridge
Use this feature to enable or disable LLDP nearest bridge state. The options are Disabled
and Enabled.
Auto-negotiation Protocol
Use this feature to select the protocol used during auto negotiation. The options are IEEE
and BAM, IEEE and Consortium, IEEE 802.3by, BAM only, and Consortium Only.
Media Auto Detect
Select enable for the rmware to automatically detect the link transceiver. The options are
Disabled and Enabled.
Default EVB Mode
Use this feature to select the default edge virtual bridging mode. The options are VEB,
VEPA, and None.
Enable PME Capability
Use this feature to enable or disable PME capability support. The options are Disabled
and Enabled.
Open Virtual Switch
Use this feature to enable or disable Open Virtual Switch. The options are Enabled and
Disabled.