Supermicro X12STL-IF - Page 76

Super X12STL-IF User's Manual
76
PCIe Speed
Use this feature to select the PCI Express port speed. The options are Auto, Gen1,
Gen2, and Gen3.
Port 61h Bit-4 Emulation
Select Enabled to enable the emulation of Port 61h bit-4 toggling in System Management
Mode (SMM). The options are Disabled and Enabled.
PCIe PLL SSC
Use this feature to enable or disable PCIe PLL SSC. The options are Enabled and Disabled.
Super IO Conguration
• Super IO Chip AST2600
Serial Port 1 Conguration
Serial Port
Select Enabled to enable the selected onboard serial port. The options are Disabled and
Enabled.
Device Settings
This feature displays the status of the serial port.
Change Settings
This feature species the base I/O port address and the Interrupt Request address of the
serial port. Select Auto to allow the BIOS to automatically assign the base I/O and IRQ
address. The options are Auto, (IO=3F8h; IRQ=4;), (IO=2F8h; IRQ=4;), (IO=3E8h; IRQ=4;),
and (IO=2E8h; IRQ=4;).
Serial Port Console Conguration
COM1 Console Redirection
Select Enabled to enable console redirection support for the serial port. The options are
Disabled and Enabled.
*If the feature above is set to Enabled, the following features are available for
conguration: