Supermicro X12STL-IF - Page 81

Chapter 4: BIOS
81
SATA Mode Selection
Use this feature to select the SATA mode. The options are AHCI and Intel RST Premium
With Intel Optane System Acceleration.
*If the feature above is set to Intel RST Premium With Intel Optane System Acceleration,
the next four features are available for conguration:
SATA Interrupt Selection
Use this feature to select the SATA interrupt. The options are MSI-x, MSI, and Legacy.
Aggressive LPM Support
When this feature is set to Enable, the SATA AHCI controller manages the power usage of
the SATA link. The controller puts the link in a low power mode during extended periods of I/O
inactivity and then returns the link to an active state when I/O activity resumes. The options
are Disabled and Enabled.
SATA Port 0-5
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
SATA Port 0-5 Hot Plug
Set this feature to Enable for hot plug support, which allows you to replace a SATA drive
without shutting down the system. The options are Disable and Enable.
SATA Port 0-5 Spin Up Device
Set this feature to enable or disable the PCH to initialize the device. The options are Disable
and Enable.
SATA Port 0-5 SATA Device Type
Use this feature to specify if the SATA port specied should be connected to a Solid State
Drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
PCH-FW Conguration
The following rmware information will display:
• General ME Conguration
• Operation Firmware Version
• Backup Firmware Version
• Recovery Firmware Version
• ME Firmware Status #1