Supermicro X13SAE - Page 15

15
Chapter 1: Introduction
Connector Description
12V_PUMP_PWR1 12V 4-pin Power Connector (for CPU liquid cooling pump)
AUDIO Back Panel High Denition Audio Ports
AUDIO_FP Front Panel Audio Header
BT1 Onboard Battery
COM1 COM Header
CPU_FAN1, CPU_FAN2
SYS_FAN1 - SYS_FAN3
CPU_FAN1, CPU_FAN2: CPU Fan Headers
SYS_FAN1 - SYS_FAN3: System Fan Headers
DP Back Panel DisplayPort (1.4a)
HDMI Back Panel High Denition Multimedia Interface (2.0b)
DVI Digital Video Interface (DVI-D)
I-SATA0 - I-SATA7 Intel Serial ATA (SATA 3.0) Ports (6Gb/second)
IPMI_LAN Dedicated IPMI LAN Port (X13SAE-F only)
JF1 Front Control Panel Header
JL1 Chassis Intrusion Header
JLED1 3-pin Power LED Header
JPI2C1 Power Supply SMBus I
2
C Header
JPW1 24-pin ATX Main Power Connector (Required)
JPW2 +12V 8-pin CPU Power Connector (Required)
JSD1 SATA Disk-On-Module (DOM) Power Connector
JSTBY1 Standby Power Header (5V)
JTPM1 Trusted Platform Module (TPM)/Port 80 Header
LAN1 RJ45 1GbE LAN Port
LAN2 RJ45 2.5GbE LAN Port
MH10,MH14, MH15 M.2 Device Mounting Holes
PCI-E M.2-M1,
PCI-E M.2-M2
PCIe 4.0 x4 M.2 M-key Sockets (from PCH)
PCI-E M.2-M3 PCIe 4.0 x4 M.2 M-Key Socket (from CPU)
SLOT1 PCI 33MHZ PCI Slot (32 Bit/33MHz with 5V single voltage)
(PCH) SLOT2, (PCH) SLOT5 PCIe 3.0 x4 Slots
(CPU) SLOT4 PCIe 5.0 x8 (IN x16) Slot
(CPU) SLOT7 PCIe 5.0 x16 Slot
SP1 Internal Speaker/Buzzer
UID Unit Identier (UID) Switch (X13SAE-F only)
USB0, USB1 Back Panel USB 2.0 Ports (Type-A)
USB2/3 Front Access USB 2.0 Header
USB4/5 Front Access USB 3.2 Gen. 1 Header (5Gb)
USB6 Internal USB 3.2 Gen. 1 Connector (5Gb, vertical Type-A)
USB7, USB8, USB9 Back Panel USB 3.2 Gen. 2 Ports (10Gb, Type-A)
USB10 Back Panel USB 3.2 Gen. 2x2 Ports (20Gb, Type-C)
USB11 Front Access USB 3.2 Gen. 2x2 Header (20Gb, Type-C)
VGA VGA Port (X13SAE-F only)