Supermicro X13SEI-TF - Page 110

Super X13SEI-TF/-F User's Manual
110
When SEL is Full
This feature allows you to determine what the BIOS should do when the system event log
is full. Select Erase Immediately to erase all events in the log when the system event log is
full. The options are Do Nothing and Erase Immediately.
Note: All values changed here do not take e󰀨ect until computer is restarted.
BMCNetworkConguration
BMCNetworkConguration
UpdateBMCLANConguration
Select Yes for the BIOS to implement all IP/MAC address changes upon next system boot.
The options are No and Yes.
********************************
CongureIPv4Support
******************************
BMC LAN Selection
Use this feature to select the type of the IPMI LAN. The default setting is Failover.
BMC Network Link Status
This feature displays the status of the IPMI network link for this system. The default setting
is Dedicated LAN.
CongurationAddressSource(Availablewhen"UpdateIPMILANConguration"is
set to Yes)
Use this feature to select the source of the IPv4 connection. If Static is selected, you will
need to know the IP address of IPv4 connection and enter it to the system manually in the
eld. If DHCP is selected, the BIOS will search for a Dynamic Host Conguration Protocol
(DHCP) server in the network that is attached to and request the next available IP address
for this computer. The options are DHCP and Static.
StationIPAddress(Availablewhen"CongurationAddressSource"issettoStatic)
This feature displays the Station IP address in decimal and in dotted quad form (i.e.,
172.29.176.131).
SubnetMask(Availablewhen"CongurationAddressSource"issettoStatic)
This feature displays the sub-network that this computer belongs to. The value of each three-
digit number separated by dots should not exceed 255.