Supermicro X13SRA-TF - Page 57

57
Chapter 2: Installation
Speaker/Buzzer Header
On the JD1 header, pins 1-4 are for the speaker and pins 3-4 are for the buzzer. If you wish
to use an external speaker, connect its cable to pins 1-4.
Speaker Connector
Pin Denitions
Pin# Signal
1-4 Speaker
3-4 Buzzer (Default)
Internal Speaker/Buzzer
The Internal Speaker/Buzzer (SP1) is used to provide audible indications for various beep
codes. Refer to the table below for pin denitions.
Internal Buzzer
Pin Denitions
Pin# Denition
1 Pos (+) Beep In
2 Neg (-) Alarm Speaker
1. Speaker Conntector (JD1)
2. Internal Speaker/Buzzer (SP1)
BAR CODE BAR CODE
IPMI CODE
MAC CODE MAC CODE SAS CODE
JTPM1
SP1
USB9 (3.2)
(USB3.2 GEN2X2)
UID-LED
JPI2C1
M.2-C01 LED
M.2-C02 LED
JF1
JWD1
JPL1
JPUSB1
JPL2
JSD1
FAN2
HD AUDIO
AUDIO FP
JUIDB1
LED8
COM1
USB0/1
FANB
FANC
BATTERY
DIMME2 DIMMF2 DIMMF1 DIMME1
DIMMA2 DIMMA1 DIMMB2 DIMMB1
SATA 1
SATA 0
SATA 3
SATA 2
SATA 4
SATA 5
M.2-C01
M.2-C02
JPME2
JL1
JRK1
(RAID Key Header)
JCMOS
JBT1
JPW2
JPW3
FAN1
FANA
JSTBY1
CPU SLOT6 PCIe 5.0 X16
JOH1
JPW1
12V_ PUMP_PWR1
USB8
(USB3.2 GEN2X2)
VGA
CPU SLOT4 PCIe 5.0 X16
PCH SLOT1 PCIe 4.0 X4
CPU SLOT2 PCIe 5.0 X16
BMC LED
JSPDIF_OUT
JPAC1
CPU
PCH
BIOS LICENSE
LAN
CTRL
BMC
USB6/7
(USB3.2 GEN2)
LAN1
USB4/5
(USB3.2 GEN2)
LAN2
Power LED
(PCIe 5.0 X4)
(PCIe 5.0 X4)
X13SRA-TF
DESIGNED IN USA
REV:1.01
JD1
(SPEAKER 1-4)
USB2/3 (3.0)
(USB3.2 GEN1)
LAN
CTRL
2
1