C-2
X8SIL/X8SIL-F User’s Manual
5. When the Boot Sector Recovery Process is complete, the system will reboot
automatically and you will see a checksum error on your screen.
Part 2: BIOS Reprogramming (Re-Flashing)
After completing the Boot Sector Recovery Process, you will need to reprogram
(“re-ash”) the proper BIOS binary le again into the BIOS ROM in order to have
the correct BIOS le loaded by the system. For details on how to ash/re-ash a
BIOS, please check our website for “Update your BIOS”, or see the section 3-3
(FAQ) of this manual. DO NOT INTERRUPT THIS PROCESS!
When completed, the system will reboot automatically, and you will see a checksum
error again.
Press “F1” to go to setup. Press “F9” to load the defaults and then press “F10” to
save and exit.
C-2 Recovery Process from an IDE/SATA ATAPI Disc
Drive
This process is identical to the Boot Sector Recovery Process from a USB Device/
Drive (as above), except that the BIOS image le (“super.rom”) is loaded from an
IDE/ATAPI CD/DVD/ROM/RW disc drive that is attached to the system. Note that
loading from an IDE/SATA hard disk drive is NOT supported.
1. Using a different system, download and copy the correct BIOS binary image
into a writable CD/DVD disc's Root "\" Directory. Rename the downloaded le to
"super.rom", so the recovery process can recognize and read the BIOS binary
le.
Note: Record/Burn the CD/DVD-R/RW disc using the ISO 9600 standard format.
Refer to your CD/DVD mastering application documentation for instructions on
how to do this.
2. Insert the newly-created disc into the IDE/SATA ATAPI CD/DVD ROM/RW
drive of the system that has the corrupted BIOS and power the system down.
3. Follow the step-by-step instructions under Part 1 - Recovery Process from a
USB Device/Drive (above) starting from Step 3 and continue on to Part 2 - BIOS
Reprogramming (Re-Flashing).
If your system still does not boot up after performing the above procedure, then
there may be other issues with your motherboard. Please contact your customer
service representative.
To Next Page
Loading...
Need help?
General
