3-6
X8SIL/X8SIL-F User's Manual
3-4 Battery Removal and Installation
Power off your system and unplug
your power cable.
1
2
3
Using a tool such as a pen or a small
screwdriver, push the battery lock
outwards to unlock it.
Once unlocked, the battery will pop
out from the holder.
Locate the onboard battery as shown
on the right.
Battery Lock
4
5
Remove the battery.
Battery
Battery Holder
Battery Installation
To install an onboard battery, follow the steps 1~2 above and continue below:
Indentify the battery's polarity. The
positive (+) side should be facing up.
1
This side should always
face up.
Warning: When replacing a battery,
be sure to only replace it with the
same type.
Insert the battery into the battery
holder and push it down until you hear
a click to ensure that the battery is
securely locked.
2
1
Click!
2
Battery Removal
To remove the onboard battery, follow the steps below:
Battery Disposal: Please handle used batteries carefully. Do not damage
the battery in any way; a damaged battery may release hazardous materials
into the environment. Do not discard a used battery in the garbage or a public
landll. Please comply with the regulations set up by your local hazardous
waste management agency to dispose of your used battery properly.
To Next Page
Loading...
Need help?
General
