To Next Page

To Previous Page

4-12

X8SIL/X8SIL-F

32-Bit Data Transfer

Select Enable to enable the function of 32-bit IDE data transfer. The options are

Enabled and Disabled.

PCI/PnPConguration

This feature allows the user to set the PCI/PnP congurations for the following

items:

Clear NVRAM

This feature clears the NVRAM during system boot. The options are No and

Yes.

Plug & Play OS

Selecting Yes allows the OS to congure Plug & Play devices. (This is not required

for system boot if your system has an OS that supports Plug & Play.) Select No to

allow the AMI BIOS to congure all devices in the system.

PCI Latency Timer

This feature sets the latency Timer of each PCI device installed on a PCI bus. Select

64 to set the PCI latency to 64 PCI clock cycles. The options are 32, 64, 96, 128,

160, 192, 224 and 248.

PCI IDE Bus Master

When enabled, the BIOS uses PCI bus mastering for reading/writing to IDE drives.

The options are Disabled and Enabled.

PCIE I/O Performace

This feature selects the setting for the IOH PCIE maximum payload size. The op-

tions are 128B and 256B.

PCI Slots 5, 6, 7 & PCI Slot 4 OPROM

Use this feature to enable or disable PCI slot Option ROMs. The options are Dis-

abled and Enabled.

Onboard LAN Option ROM Select

This feature selects whether to load the iSCSI or PXE onboard LAN option ROM.

The options are iSCSI and PXE.

Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM

This feature is to enable or disable the onboard option ROMs. The options are

Disabled and Enabled.

Supero X8SIL User Manual

Questions and Answers: