Chapter 7 Installation
www.supmea.com
Chapter 7 Installation
(1) Pressure transmitter should be installed as far as
possible in the place where temperature fluctuation is
small, while avoiding vibration and shock.
(2) The pressure transmitter can be directly installed at the
measuring point. Connection threads: M20*1.5 or
1/2-NPT. Flange Interfaces of various specifications for
special purposes.
(3) Transmitter is suitable for measuring the pressure of
various general corrosive liquids and gas. Transmitters
manufactured according to explosion-proof
requirements can be used in different explosive
environments according to the explosion-proof grade of
products, and their related equipment should also have
explosion-proof function. For strong corrosive medium
(such as acid, alkali) and corrosion resistant structure,
the orders should be placed according to special
requirements.
(4) Do not route the signal line through the conduit or the
open cable with the power line, or near high-power
equipment.
(5) If the pressure pipes are used in the transmitter,
attention should be paid to that the strong corrosive or
superheated media should not contact the transmitter,
so as to prevent the sediment from precipitating in the
To Next Page
Loading...
