SureTouch Refrigerated Liquid Dispensers • SureShot Technical Assistance Center: 1-888-777-9990 or 902-865-9602
7
Reset Product Level – IntelliShot (Portion Controlled) Fill-In-Place Dispensers
Resetting the levels is required after each time a tank is filled to ensure accurate
dispense amounts.
See the Job Aid on the inside of the product compartment door of the dispenser for
information that is specific to the dispenser.
1. Select the tank that has been refilled by pressing the product selection button for that
tank (eg. cream) on the button panel.
2. Within three (3) seconds, press and hold the Reset button for one (1) second. Some
dispenser models use the ▲ button as the Reset button. Refer to the Job Aid on the
inside of the product compartment door of the dispenser for information that is
specific to the dispenser.
3. Press the Reset (or ▲) button repeatedly until the LCD Display matches the level to
which the tank has been filled. Tank levels are measured in 0.5 gallon/1.89 litre
increments.
Note: Each button press must be completed within three (3) seconds until level
shown in LCD matches product level in tank.
4. The product button’s LED will turn off indicating the new refill level is stored in
memory and the Reset procedure is complete.
The dispenser is ready for use.
Remove an Empty Product Bag, Bag-In-Box or Tank
1. Place a container under the dispense valve to catch any residual product or clamp
the dispense tube.
2. Open the product compartment door.
3. Open the valve door by turning the black thumbscrew counter-clockwise to loosen.
4. Fold and pinch the product delivery tube to reduce drips (if not clamped).
5. Remove the product case with bag, bag-in-box or tank.
6. Discard the empty product bag or bag-in-box.
7. Clean the product tank. See Product Tanks and Lids on page 14.
DISPENSING PRODUCT
IntelliShot (Portion Controlled) Dispensers
Note: Not all selections are available on all models.
1. Place cup under dispense point of desired product.
2. Press Product button (milk, cream, etc.)
3. Select Beverage Type. (Optional. Eg. hot chocolate, latte, etc.)
Most dispensers default to coffee.
If there are no Beverage Type buttons, skip this step.
4. Select cup size or amount.
5. Press Dispense to dispense product or Cancel to cancel selections.
For models that do not have Dispense and Cancel buttons, the product will dispense
after pressing the cup size or amount button.
Note: Once the product is dispensed or selections are cancelled, the LCD cycles back to
Select Product.
Dispenser returns to normal operating conditions after three (3) seconds of inactivity.
FlexoShot (Manually Operated) Dispensers
1. Place cup under dispense point of desired product.
2. Press lever down until desired portion is dispensed.
To Next Page
Loading...
Need help?
General
