SurgeX Defender Series - Wiring Fault; Abnormal Voltage

User Manual
© 2013 SurgeX / Electronic Systems Protection, Inc. / Technical Support 800.645.9721 / www.surgex.com / 10
3.1.2. Wiring Fault
When connected to an incorrectly wired branch circuit outlet, in addition to the illumination of the Red LED,
the LCD Event Monitor will display the following information:
3.1.3. Abnormal Voltage
When the magnitude of the branch circuit outlet voltage is not acceptable*, the Surge +
Diagnostic will disconnect power to its outlets and display the following information on the
LCD Event Monitor (*above the over-voltage shutdown threshold or below the under-
voltage shutdown threshold; refer to Section 4: Diagnostic Software for more information):
3.2