12
After every battery replacement, it is necessary to calibrate the magnetic sensor. Refer to Chapter
5, Calibrating the Compass.
CHAPTER 2 TIME MODE
There are three time submodes: time, chronometer and alarms.
NOTE: These functions are accessible in the TIME mode, i.e. when the mode indictor is below
TIME.
In the watch time mode, the fields display the following data as shown in Fig. 2.1:
a) Day of the week;
b) Current time;
c) Date dd.mm in 24h display or mm.dd in 12h display, seconds or dual time according to the
last selection (changing data with the [ON OFF] button;
d) Am/pm indicator in 12 h display; and
e) Graphical display of seconds, once every two seconds a new segment lights up until a full
circle of segments (60 seconds) is lit.
SETTING UP THE TIME AND CALENDAR FUNCTIONS
1. In the main mode of the time function, press the [SELECT] button for 2 seconds to begin the
setup process. In the bottom field, seconds will begin to flash.
2. Press the [SELECT] button to move to the field you want to change. The order of fields is
seconds, minutes, hours, 12/24h, year, month, day, dual-time hours, dual-time minutes. You
change the value in the field that is flashing.
3. Press the [ON OFF] button to scroll the value in the field up or the [QUICK] button to scroll
down. In the seconds field, the [QUICK] button resets the seconds to zero.
4. Press the [MODE] button to accept the changes made and exit the setup process.
To Next Page
Loading...
