6
ADJUSTING THE BRACELET (ST AND TT MODELS)
The metal / elastomer bracelets of the Observer models St
and Tt have to be adjusted for the user. The steps are
1. Remove the buckle by releasing the spring bars with
pin, paper clip or other sharp object.
2. Remove both spring bars from the pin holes.
3. Shorten the bracelet by cutting along the grooves
on the inner surface of the bracelet. You can do this
for instance with scissors. If you are unsure of the
correct length, cut the pieces one by one and test
the length after cutting each piece. Cut in turns from
both sides of the bracelet to keep the sides equally
long. Be careful in order not to shorten the bracelet
too much.
4. Replace the spring bars into the last pin holes of
both sides of the bracelet.
5. Attach the buckle to the bracelet by placing the
spring bars into the holes in the buckle. In both sides
of the buckle are holes for two different positions.
This can be used for fine adjusting of the bracelet
length. Make sure that the spring bars are positioned
straight in the buckle.
æ
å
æ
å
To Next Page
Loading...
