33
2. Press the [ON OFF] or the [QUICK] button to select the declination direction in the top
field.
3. Press the [SELECT] button to move to the next setting. In the middle field, the degrees will
begin to flash.
4. Press the [ON OFF] button to scroll the degrees up or the [QUICK] button to scroll down.
5. At the degrees desired, press the [MODE] button to accept the changes and exit.
Local Declination is now set.
NOTE: You can find the local declination in the maps of your area.
Setup mode will automatically exit if left idle for more than one minute.
CALIBRATING THE COMPASS
A compass calibration should be done whenever the Observer is exposed to a strong magnetic
source, extreme cold weather, the battery is replaced, or you suspect that other environmental
conditions have affected the compass readings. If you notice that the compass is not showing
the direction correctly, you should do the calibration.
NOTE: Calibrate the compass before you use it for the first time, and before you leave for an
extended outdoor activity.
To begin the calibration:
1. Press the [SELECT] button twice when in the main compass mode. The top field displays
the text CMP, and the bottom field displays the text CAL (Fig. 5.4).
2. Press the [SELECT] button for 2 seconds. In the middle field, the text PUSH will begin to
flash, alternating with the sign - (Fig. 5.5). This indicates the button [QUICK / -].
3. Press the [QUICK] button to start calibration. The middle field displays 360º and the LCD
ring on the outer circumference light (Fig. 5.6).
4. Hold the Observer level and slowly rotate the device in a full clockwise or counter-clock-
wise circle. As you turn, the lit LCD segments will turn off.
To Next Page
Loading...
