Suzuki DF350A - Abbreviations

General Information: 0A-2
Abbreviations
CENHN1110101002
Abbreviations used in this service manual are as follows:
A:
ATDC: After Top Dead Center
AC: Alternating Current
B:
BCM: Boat Control Module
BTDC: Before Top Dead Center
C:
CKP Sensor: Crankshaft Position sensor
CMP Sensor: Camshaft Position sensor
D:
DBW: Drive By Wire
DC: Direct Current
DOHC: Double Over Head Camshaft
E:
ECM: Engine Control Module
ETV: Electronic Throttle Valve
ESA: Electronic Shift Actuator
EX (Ex.): Exhaust
F:
FP: Fuel Pump
G:
GND: Ground
I:
IAT: Intake Air Temperature
IG: Ignition
Ign.: Ignition
IN (In.): Intake
L:
LPS: Lever Position Sensor
M:
MAP: Manifold Absolute Pressure
O:
OCV: Oil Control Valve
P:
PCV: Positive Crankcase Ventilation
PORT: Port
PTT: Power Trim and Tilt
S:
SPC System: Suzuki Precision Control System
SPS: Shift Position Sensor
STBD: Starboard
SIGP: Start-In-Gear Protection
T:
TPS: Throttle Position Sensor
V:
VSV: Vacuum Switching Valve
VVT: Variable Valve Timing
NOTE
On Keyless start system model,
The key operation described in this manual is
as follows:
• “Turn the main switch ON position”
represents that the keyless start system is
turned ON by switch knob operation.
• Conversely, “Turn the main switch OFF
position” represents that the keyless start
system is turned OFF by switch knob
operation.