Suzuki GSR600 User Manual

ENGINE 3-53
• Remove the oil seal 1.
• Remove the gearshift shaft bearing with the special tool.
 09921-20240: Bearing remover set (15 mm)
Installation
• Install the bearings with the special tool.
 09913-70210: Bearing installer set (1, 2 22)
(3 32)
NOTE:
The stamped mark side of the gearshift shaft bearing faces out-
side.
• Install the oil seal with the special tool.
 09913-70210: Bearing installer set (22)
• Apply SUZUKI SUPER GREASE “A” to the oil seal lip.
 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
• Install the gearshift cam 4 with the bearing 5.
NOTE:
The stamped mark side of the gearshift cam bearing faces out-
side.

Suzuki GSR600 Specifications

General

Engine Type	4-stroke, 4-cylinder, liquid-cooled, DOHC
Displacement	599 cc
Compression Ratio	12.5:1
Fuel System	Fuel injection
Ignition	Electronic ignition (transistorized)
Lubrication	Wet sump
Starter	Electric
Transmission	6-speed, constant mesh
Final Drive	Chain
Front Suspension	Telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Dual hydraulic disc
Rear Brakes	Single hydraulic disc
Front Tire	120/70ZR17M/C (58W), tubeless
Rear Tire	180/55ZR17M/C (73W), tubeless
Bore x Stroke	67.0 mm x 42.5 mm
Overall Length	2, 090 mm
Overall Width	795 mm
Wheelbase	1440 mm
Ground Clearance	130 mm
Seat Height	785 mm
Fuel Tank Capacity	16.5 L