ENGINE 3-27
ENGINE COMPONENTS INSPECTION
AND SERVICE
CYLINDER HEAD COVER
• Clean and check the gasket groove A and PAIR reed valve
gasket mating surfaces B of cylinder head cover.
• If it is damaged, replace the cylinder head cover with a new
one.
CMP SENSOR
REMOVAL
• Remove the CMP sensor 1 from the cylinder head cover.
INSPECTION
• Inspect the CMP sensor. (4-32)
INSTALLATION
• Install the oil seal 1 and CMP sensor.
NOTE:
When installing, clean the CMP sensor’s surface.
CMP sensor bolt: 11 N·m (1.1 kgf-m)
PAIR REED VALVE
REMOVAL
• Remove the PAIR reed valve 1 from the gasket.
Identify the position of each removed part. Organize
the parts in their respective groups (i.e., intake,
exhaust, No.1 or No.2) so that they can be installed in
their original locations.
To Next Page
Loading...
