Suzuki GSR600 - Engine Installation

ENGINE 3-9
• Remove the engine mounting nut 4.
• Loosen the engine mounting thrust adjuster lock-nut 5 with
the special tool.
• Loosen the engine mounting thrust adjuster 6.
 09940-14980: Engine mounting thrust adjuster socket
wrench
NOTE:
Do not remove the engine mounting bolt
7 at this stage.
• Remove the engine mounting bolt 7. Then, take off the drive
chain from the driveshaft.
• Remove the engine assembly.
ENGINE INSTALLATION
Install the engine in the reverse order of removal.
Pay attention to the following points:
NOTE:
Be careful not to damage the frame and engine when installing
the engine.
• Before installing the engine, install the engine mounting thrust
adjuster 1.
• Gradually raise the rear side of the engine assembly, and
then put the drive chain on the driveshaft.
• Install all engine mounting bolts and tighten them temporarily.
(3-11)

Be careful not to catch the wiring harness between the
frame and the engine.