ENGINE 3-25
MIDDLE CRANKCASE
• Remove the crankcase bolts (M6).
• Remove the crankcase bolts (M6), clamp 1 and regula-
tor/rectifier backet 2.
• Remove the crankshaft journal bolts (M9).
NOTE:
Loosen the crankcase bolts diagonally with the smaller sizes
first.
CRANKSHAFT
• Loosen the bearing cap bolts using a 10 mm, 12 point-socket
wrench, and tap the bearing cap bolts lightly with a plastic
hammer to remove the bearing cap.
• Remove the dowel pins.
• Remove the O-ring 1.
• Remove the crankshaft and thrust washers 2.
PISTON AND CONROD
• Push the conrod to cylinder head side and remove the piston
and conrod from the upper crankcase.
Be careful not to damage the cylinder wall by the con-
rod.
To Next Page
Loading...
