2-14
When the display indicates “CHEC” in
the odometer display area, check the
following items;
• Make sure that the engine stop
switch is in the “” position.
• Make sure that the transmission is
in neutral or the side stand is fully
up.
If the display still indicates “CHEC”
after checking the above items,
inspect the ignition fuse and the con-
nection of the lead wire couplers.
HIGH BEAM INDICATOR LIGHT
“” 0
This blue indicator light will be lit
when the headlight high beam is
turned on.
CLOCK A
Time is shown when the ignition
switch is in the “ON” position. The
clock has a 12-hour display. Follow
the procedure below to adjust the
clock.
To adjust the clock, press and hold
the SEL button 1 and the ADJ button
7 simultaneously for 2 seconds until
the clock hour display blinks.
Push the ADJ button 7 to adjust the
hour display.
Push the SEL button 1 and the clock
minute display blinks. Push the ADJ
button 7 to adjust the minute display.
Push the SEL button 1 to return to
the clock mode.
NOTE:
• When the ADJ button 7 is
pressed and held, the display will
increase continuously.
• The clock can be adjusted when
the ignition switch is in the “ON”
position.
• This clock is powered by the bat-
tery of the motorcycle. If your
motorcycle is to be left unused
more than two months, remove
the battery from the motorcycle.
OFF
TC
TC
1
2
3
H
E
km/h
mph
F
C
N
SEL ADJ
GEAR
km/L/100km
TRIP
1000r/min
RANGE
MPGUSIMP
AVG
A B
A
B
TRIP
To Next Page
Loading...
