7-43
7. Pull the rear wheel assembly
rearward.
NOTE: Never depress the rear
brake pedal with the rear wheel
removed. It is very difficult to force
the pads back into the caliper
assembly.
8. To replace the wheel reverse
the complete sequence listed.
9. Adjust the drive chain slack.
10.After installing the wheel,
apply the brake several times
and then check that the wheel
rotates freely.
Rear axle nut tightening torque:
100 N·m (10.0 kgf-m, 72.5 lbf-ft)
WARNING
Failure to adjust the drive chain
and failure to torque bolts and
nuts properly could lead to an
accident.
• Adjust the drive chain as
described in DRIVE CHAIN
ADJUSTMENT section after
installing the rear wheel.
• Torque bolts and nuts to the
proper specifications. If you
are not sure of the proper
procedure, have your autho-
rized SUZUKI dealer or a
qualified mechanic do this.
WARNING
Failure to extend brake pads
after installing the wheel can
cause poor braking perfor-
mance and may result in an
accident.
Before riding, “pump” the
brake pedal repeatedly until
brake pads are pressed against
the brake disks and proper
pedal stroke and firm feel are
restored. Also check that the
wheel rotates freely.
PartShark.com
877-999-5686
To Next Page
Loading...
