Suzuki GSX1300R - Page 35

3-17
Suzuki Drive Mode Selector 4
Engine power characteristics can
be changed in 3 modes by operat-
ing the Suzuki drive mode selec-
tor to meet various riding
conditions and rider’s preference.
Suzuki drive mode selector
operation
Drive mode is preset at A-mode
when the ignition switch and the
engine stop switch are turned on.
At this time, the Suzuki drive
mode indicator shows nothing.
Follow the procedure below to
operate the Suzuki drive mode
selector.
1. Turn on the ignition switch and
the engine stop switch.
2. Start the engine.
3. Push the Suzuki drive mode
selector for 2 seconds until the
Suzuki drive mode indicator
shows A.
4. Push the Suzuki drive mode
selector to change drive mode.
Pushing the upper part can
change from A to C to B to A.
Pushing the lower part can
change from A to B to C to A.
The Suzuki drive mode indica-
tor indicates actual drive
mode.
NOTE:
• Operating the Suzuki drive
mode selector while riding with
the throttle opened will change
the engine speed because of
engine power characteristics
change.
• The Suzuki drive mode indica-
tor blinks when drive mode
change operation is failed.
• Turning off the ignition switch
or the engine stop switch will
return the drive mode to A-
mode. Start the engine and
reset the drive mode.
Drive mode
Engine power
Throttle opening
A-mode
A-mode provides sharp throttle
response at all throttle opening
range to obtain maximum engine
power.
B-mode
B-mode provides softer throttle
response than A-mode at all throt-
tle opening range.
C-mode
C-mode provides softer throttle
response than B-mode at all throt-
tle opening range.
MODE
A
B
C
B
A
C
PartShark.com
877-999-5686