1D-38 Engine Mechanical:
Balancer
1) Remove the balancershaft driven gear (1).
2) Remove the key (2).
3) Remove the balancershaft with the special tools.
Special tool
(A): 09930–30104 (Rotor remover slide
shaft)
(B): 09930–30141 (Attachment A)
Crankshaft
1) Remove the crankshaft with the special tool.
NOTE
When removing the crankshaft, remove the
gearshift cam stopper stud bolt, then use the
thread for the special tool.
Special tool
: 09920–13120 (Crankcase separating tool)
Drive Bevel Gear and Output Shaft
Remove the drive bevel gear (1) and output shaft. Refer
to “Transfer Removal and Installation (LT-F400/F) in
Section 3C (Page 3C-7)”.
LT-F400/F
NOTE
The crankcase must be separated to service
the crankshaft and conrod.
1) Remove the engine assembly from the frame. Refer
to “Engine Assembly Removal (Page 1D-6)”.
2) Remove the engine top side. Refer to “Engine Top
Side Disassembly (Page 1D-10)”.
Starter Motor
1) Remove the starter motor (1).
Starter Cup
1) Remove the starter cup nut with a suitable bar.
2) Remove the starter cup (1).
1
2
I827H1140118-01
(A)
(B)
I827H1140255-01
(A)
I827H1140256-01
1
I827H1140257-01
1
I827H1140120-01
1
I827H1140121-01
To Next Page
Loading...
