3C-19 Transfer:
• Install the gearshift shaft assembly by aligning the
punch mark of shift gear with the match mark of
gearshift cam stopper plate.
• Install the generator cover. Refer to “Generator
Removal and Installation in Section 1J (Page 1J-5)”.
• Pour engine oil. Refer to “Engine Oil and Filter
Replacement in Section 0B (Page 0B-7)”.
Gearshift Linkage Inspection (LT-A400/F)
B827H13306015
Refer to “Transfer Gearshift Shaft No. 2 / Gearshift Cam
Plate Removal and Installation (LT-A400/F) (Page 3C-
17)”.
Gearshift Shaft
Check the gearshift for bend or wear.
Check the return spring for damage or fatigue.
If any defects are found, replace the defective part(-s).
Gearshift Shaft Oil Seal
Inspect the gearshift shaft oil seal lip for damage or
wear. If any defect are found, replace the oil seal with a
new one.
Gearshift Shaft Oil Seal Removal and
Installation (LT-A400/F)
B827H13306016
Removal
• Remove the generator cover. Refer to “Generator
Removal and Installation in Section 1J (Page 1J-5)”.
• Remove the gearshift shaft oil seal (1).
Installation
Install the oil seal in the reverse order of removal. Pay
attention to the following points:
CAUTION
!
The removed oil seal must be replaced with
new one.
• Install the oil seal with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
• Install the generator cover. Refer to “Generator
Removal and Installation in Section 1J (Page 1J-5)”.
I827H1330045-02
I827H1330046-01
I827H1330047-01
1
I827H1330048-01
(A)
I827H1330049-02
To Next Page
Loading...
