Transfer: 3C-18
6) Remove the spring (11) and gearshift cam stopper
(12).
Installation
Install the gearshift shaft and gearshift cam plate in the
reverse order of removal. Pay attention to the following
points:
• Apply a small quantity of thread lock to the thread of
gearshift cam stopper bolt.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
• Tighten the nut (1) to the specified torque.
NOTE
Hook the return spring end to the stopper.
Tightening torque
Gearshift cam stopper nut (a): 10 N·m (1.0 kgf-m,
7.0 lb-ft)
• Check the gearshift cam stopper moves smoothly.
• Locate the gearshift cam in the neutral position.
• Install the washer (2) and gearshift cam stopper plate
(3).
NOTE
• Align the gearshift cam pin “A” with the
gearshift cam stopper plate hole “B”.
• When installing the return spring, position the stopper
“C” of gearshift shaft No. 2 and stopper “D” of shift
gear between the return spring ends.
• Install new snap ring (4) and washer (5).
CAUTION
!
The removed snap ring must be replaced
with a new one.
12
11
I827H1330039-02
I827H1330040-01
(a)
1
I827H1330041-02
3
2
“A”
“B”
I827H1330042-02
“C”
“D”
I827H1330043-01
5
4
I827H1330044-01
To Next Page
Loading...
