Manual Transmission: 5B-8
5) Remove the gear position switch (2).
6) Remove the switch contacts and springs.
Installation
Install the gear position switch in the reverse order of
removal. Pay attention to the following points:
• Apply a bond lightly to the gear position switch lead
wire grommet (1).
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
• Install the generator cover. Refer to “Generator
Removal and Installation in Section 1J (Page 1J-5)”.
• Route the gear position switch lead wire. Refer to
“Wiring Harness Routing Diagram in Section 9A
(Page 9A-8)”.
• Install the generator cover. Refer to “Generator
Removal and Installation in Section 1J (Page 1J-5)”.
Gear Position (GP) Switch Removal and
Installation (LT-A400/F)
B827H15206020
Refer to “Gear Position (GP) Switch Removal and
Installation (LT-A400/F) in Section 3C (Page 3C-16)”.
Gearshift Lever Removal and Installation (LT-
F400/F)
B827H15206017
Removal
1) Remove the left footrest mudguard. Refer to
“Exterior Parts Removal and Installation in Section
9D (Page 9D-3)”.
2) Remove the gearshift link arm (1).
3) Remove the left footrest. Refer to “Footrest Removal
and Installation in Section 9E (Page 9E-2)”.
4) Remove the gearshift lever assembly (2) from the
footrest by removing the snap ring(3).
Special tool
: 09900–06107 (Snap ring pliers)
2
I827H1520017-01
I827H1520018-01
1
I827H1520019-01
1
I827H1520033-01
3
2
I827H1520034-01
To Next Page
Loading...
