Suzuki LT-F400F - Specifications; Tightening Torque Specifications; Special Tools and Equipment; Recommended Service Material

3A-11 Drive Chain / Drive Train / Drive Shaft:
• Install the dust seal with special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
Specifications
Tightening Torque Specifications
B827H13107001
NOTE
The specified tightening torque is also described in the following.
“Rear Axle Components (Page 3A-6)”
“Rear Axle Construction (Page 3A-7)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List (LT-A400/F) in
Section 0C (Page 0C-9)”.
Special Tools and Equipment
Recommended Service Material
B827H13108001
NOTE
Required service material is also described in the following.
“Front Drive Shaft Components (LT-A400F, LT-F400F) (Page 3A-1)”
“Rear Axle Components (Page 3A-6)”
“Rear Axle Construction (Page 3A-7)”
Special Tool
B827H13108002
(A)
I827H1310023-01
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Rear axle housing mounting bolt (Final gear
case)
55 5.5 40.0
)(Page 3A-9)
Rear axle housing mounting nut (swingarm) 60 6.0 43.5 )(Page 3A-9)
Material SUZUKI recommended product or Specification Note
Grease SUZUKI SUPER GREASE A or
equivalent
P/No.: 99000–25010 )(Page 3A-2) / )(Page 3A-
8) / )(Page 3A-8) /
)(Page 3A-10)
09900–06107 09900–06108
Snap ring pliers Snap ring pliers
)(Page 3A-3) / )(Page 3A-
4)
)(Page 3A-10)