Propeller Shafts: 3D-11
Assembly
Assemble the front drive shaft in the reverse order of
removal. Pay attention to the following points:
• Install the spacer using a suitable size tool and
hydraulic press.
NOTE
The bearing knock-pin “A” should be
positioned inside.
• Apply grease to the lip “B” of the oil seal.
• Install new oil seal to the front output shaft.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
CAUTION
!
Replace the removed oil seal with a new one.
NOTE
The lip “B” of the oil seal should be
positioned outside.
• Install new snap ring (1) and circlip (2).
CAUTION
!
Replace the removed snap ring and circlip
with new ones.
Rear Output Shaft Related Parts Inspection
B827H13406019
Refer to “Rear Output Shaft Disassembly and Assembly
(LT-F400/F) (Page 3D-7)”.
Rear Output Shaft
Inspect the rear output shaft for wear or damage. If any
defects are found, replace the rear output shaft with a
new one.
“A”
I827H1340088-01
I827H1340055-02
[A]: LT-A400/F [B]: LT-F400/F
1
3
2
I827H1340056-02
[A]
I827H1340084-01
[B]
I827H1340085-01
To Next Page
Loading...
