Engine Mechanical: 1D-45
• Install the washers (4), bearing (5) and gearshift shaft
(6).
• Install the washer (7).
• Install the gearshift forks (8) (9) and transfer output
shaft assembly (10).
NOTE
Each gearshift fork has own embossed
letters.
• Install the transfer input shaft assembly (11).
• Install the shaft (12), spacer (13) and bearing (14).
• Install the reverse idle gear (15) and washer (16).
Crankcase
• Wipe the crankcase mating surfaces (both surfaces)
with a cleaning solvent.
• Fit the dowel pins onto the left half on the crankcase.
• Apply engine oil to the conrod big end the gears.
“A”: 44D-TL (For reverse gear)
“B”: 44D-TM (For HIgh/Low gear)
“A”
“A”
I827H1140156-01
5
4
6
7
I827H1140157-01
8
9
10
I827H1140158-01
“A”
“B”
I827H1140262-01
11
I827H1140159-01
12
13
14
15
16
I827H1140160-01
I827H1140161-01
To Next Page
Loading...
