Suzuki LT-F400F - Page 458

6B-7 Steering / Handlebar:
5) Remove the steering shaft holders (1) and dust seals
(2).
6) Remove the dust seal (3), washer (4) and O-ring (5).
7) Remove the steering shaft (6).
8) Remove the dust seal (7) from the steering shaft (6).
9) Remove the steering shaft bushing (8) using the
special tools and suitable socket wrench “A”.
NOTE
If there are wear or damage, remove the
steering shaft bushing (8). Refer to “Steering
Parts Inspection (Page 6B-10)”.
Special tool
(A): 09924–84521 (Bearing installer set)
(B): 09930–31921 (Rotor remover)
Installation
Install the steering shaft/tie-rod in the reverse order of
removal. Pay attention to the following points:
Steering Shaft
• Install the steering bushing (1) using the special tool.
Special tool
(A): 09924–84521 (Bearing installer set)
1
2
I827H1620025-02
4
5
6
3
I827H1620027-02
6
7
I827H1620026-02
(A)
(B)
8
“A”
I827H1620028-02
(A)
(B)
8
“A”
I827H1620048-02
1
(A)
I827H1620029-02