9D-5 Exterior Parts:
Engine Under Cover
Removal
Remove the engine under cover (1).
Installation
Installation is in the reverse order of removal.
Front Fender
Removal
1) Remove the front carrier. Refer to “Front Carrier
Removal and Installation in Section 9E (Page 9E-4)”.
2) Remove the inner fenders.
3) Remove the side covers.
4) Remove the footrest mudguards.
5) Remove the fuel tank upper cover.
6) Disconnect the power source terminal coupler (1).
7) Disconnect the headlight couplers (2).
8) Remove the front fender with the headlight
assemblies.
9) Remove the headlight assemblies from the front
fender. Refer to “Headlight Removal and Installation
in Section 9B (Page 9B-3)”.
Installation
Installation is in the reverse order of removal. Pay
attention to the following point:
• Check the headlight beam and adjust it if necessary.
Refer to “Headlight Beam Adjustment in Section 9B
(Page 9B-4)”.
I827H1940015-01
1
I827H1940021-01
1
I827H1940017-03
2
I827H1940018-03
2
I827H1940019-03
To Next Page
Loading...
