2-6
LEFT HANDLEBAR
Rear Brake Lever 1
Apply the rear brake by squeezing the
rear brake lever towards the grip.
Parking Brake Knob 2
This knob is used to set the parking
brake, which is used to prevent the LT-
Z90 from moving when it is parked,
being started, or at idle. Set the park-
ing brake by squeezing the rear brake
lever and pushing this knob to lock
the lever in the squeezed position.
Engine Stop Switch 3
“OFF” position
The ignition circuit is off and the
engine cannot start or run.
“RUN” position
The ignition circuit is on and the
engine can run.
Electric Starter Button 4
Use this button to turn the starter
motor. Before starting the engine,
make sure the ignition switch is in the
“ON” position and the parking brake is
engaged. Push the electric starter
button to start the engine.
NOTE: This vehicle has a starter
interlock switch which prevents the
starter motor from turning when the
parking brake is not engaged.
To Next Page
Loading...
