3-35
12. Pour 3500 ml (3.7/3.1 US/Imp. qt) of new
engine oil through the filler hole and
install the filler cap. Be sure to always
use the specified engine oil described in
the “SELECTING THE ENGINE OIL”
section on page 3-25.
NOTE: About 3000 ml (3.2/2.6 US/Imp. qt)
of oil will be required when changing oil only.
13. Start the engine (while the motorcycle is
outside on level ground) and allow it to
idle for three minutes.
14. Turn the engine off and wait approxi-
mately three minutes. Recheck the oil
level in the engine oil inspection window
while holding the motorcycle upright. If it
is lower than the “L” line, add oil until the
oil level is between the “L” line and the
“F” line. Inspect the area around the
drain plug and oil filter for leaks.
NOTE: If you do not have a proper oil filter
wrench, have your dealer perform this ser-
vice.
15. Reinstall the under cover and bolts.
(V-STROM 800DE)
NOTICE
Engine damage may occur if you use oil
that does not meet Suzuki’s specifica-
tions.
Be sure to use the oil specified in the
SELECTING THE ENGINE OIL section.
To Next Page
Loading...
