HAMAMATSU-NISHI P.O. BOX 1, 432-8611 HAMAMATSU, JAPAN.
MOTORCYCLE
DATE:
May 16, 2006
PAGE
: 4
OF
13
A: Allen bolt
B: Holder
C: Front brake master cylinder
D: Handlebars
Connect the front brake light switch lead wires coupler
to the brake light switch.
A: Front brake light switch
B: Lead wire coupler
LEFT SWITCH [Page: 13, 14 Paragraph: 1]
Insert the boss of the left switch holder into the hole on
the handlebars.
Tighten the left switch assembly with the two screws.
A: Boss
B: Hole
C: 5 × 45 mm screw
D: 5 × 30 mm screw
NOTE:
Install the holder in position according to the
mark “UP”.
Make sure that the holder has no clearance at
the upper side as shown.
Check for brake fluid leakage.
Be careful not to pinch the wiring harness
between the housing and holder.
To Next Page
Loading...
