HAMAMATSU-NISHI P.O. BOX 1, 432-8611 HAMAMATSU, JAPAN.
MOTORCYCLE
DATE:
May 16, 2006
PAGE
: 3
OF
13
[Page: 9, 10 Paragraph: 3]
#
A: Front brake hose
B: Clutch hose
C: Throttle cable
D: Right switch wiring harness
E: Left switch wiring harness
THROTTLE [Page: 9, 10 Paragraph: 4]
Insert the boss of the throttle housing into the hole on
the handlebars.
Tighten the throttle assembly with two screws.
#
A: Boss
B: Hole
C: 5 × 45 mm screw
D: 5 × 35 mm screw
FRONT BRAKE MASTER CYLINDER
[Page: 11, 12 Paragraph: 2 through 4]
Install the front brake master cylinder onto the handle-
bars.
Align the dot mark on the handlebars with the master
cylinder-to-holder fitting surface.
Tighten the master cylinder mounting bolts to the
specified torque.
" Front brake master cylinder mounting bolt:
10 N·m (1.0 kgf-m)
After installing the master cylinder, fit the plastic cap
on the head of each bolt.
A: Holder
B: Front brake master cylinder
C: 6 × 20 mm Allen bolt
D: 6 × 20 mm Allen bolt
E: Dot mark
F: Plastic cap OD:10.0 mm
The line drawings on page 56 and 57 show the
proper routing of the control cables, hose and
wirings.
Refer to them in addition to following the
instructions carefully.
Check to ensure that the throttle operates
freely and closes automatically.
NOTE:
To install the holder correctly, first tighten the
bolt
C of the upper side with specified torque
and then tighten the bolt
D of the lower side.
To Next Page
Loading...
